Search:

Thanks! No I have not had any new Mirages on the alignment rack but I saw a G4 with around 20K miles on it with the fancy larger
wheels on it (that they come with) and it was ready for tires. Which...

Hey guys! Long story as short as I can. About 7 months ago purchased a Mitsubishi i-MiEV. (used with 15K miles).
Kept the Mirage for the long trips. I only HAD to drive the Mirage maybe once but I...

David! Congrats! I missed this entry before.

Darin! (MetroMPG) Yeah a lot of similarities with the Mirage like the mirrors seem identical or the weird scrolling through the menu to get to...

It's the flight recorder black box!

Or the evaporative emissions charcoal canister where the fuel vapors are stored until the ECM decides to open the purge valve so the engine can use it as fuel. ...

A while ago I modified a trailer hitch(receiver) that was given to me to fit my mirage.
Then I bought a small 4x4 foot trailer from harbor freight ($236-ish)which I am still building to make it a...

That is all a possibility and getting 38K + out of the OEM tires on a mirage is pretty good.

However uneven wear across the surface of the tire (inside to outside like he says) IS a result of the...

Yes! Especially if it has not been rotated. That would just hide the issue anyway and make all the tires wear quick.
I noticed the noise on mine at 18K miles but my rear end was terrible.

I did not really see this stated this way for the question of why the manual is getting better mileage..

The CVT requires more power input from the engine to achieve the same power output as the...

True! Metro MPG could add "I have no reason to have my alignment checked based on my tire wear and handling/drivability"!

However if your case is so good, could you add the miles driven and tread...

Mine of course. I am realizing that other than the small group of owners here at the forum,it seems nobody gives a rats about it.
Not other owners,not Mitsubishi.
They just say it has crap tires...

This guy:

7567



Had a chance to go up on the machine just to see if they "fixed" the axles for 17's.

About grinding the weld. Look at the pic on the previous page. Only about a quarter of the full welded circle is visible and you could
only get to about one little section of the circle with a...

The fuse is going to be the least likely item to be intermittent.

When the fan does not come on at all is the best time to diagnose.

Turn the ignition to run or start the car. Turn the...

Side airbag probably did not go off because it was not a side impact. Sensors for that are at the bottom of the B-pillars.



The passenger airbag instead of deploying,it fell into the glove...

If I may brag here :)

I can't beat 25Plus's killer tanks but today I saw a personal record. My car thinks there is still 850 miles (1367km) range left on top of
over 50 miles on this tank's...

Just trying to share some positive development.

Long story short.
Here is how my mirage came from the factory.
7024

My mirage is the second worst rear alignment I've seen.(including all...

Like you said,make sure the bulb is seated like it should.

The adjusters are:
One under the white cap with the red marking. The other down above the red wire (on the picture) with no cap...

Interesting. I guess the info in the manual contradicts what the alignment machine's specs show. Hunter must get their specs
from the manufacturer one would think.
See the specs in the upper...

No you don't get to keep the old parts because they have to send it back to claim the warranty repair.

About how the wheels look,you simply see the -1.5 degree camber with your eyes and the rear...

Hey Eggman!

That is not the specs for 2014-15 Mirage. Your readout would be well within specs for a Mirage. (rear camber specs actually -1.8 to -0.3 degrees.)
What does it say on the top half of...

If the links don't work here it is shortly.
Pop the plastic cover off in front of left knee.(below steering wheel down to the left.the fuse box cover).
Locate yellow square holder with two fuses in...

The sensor,yes! Depress the metal tab and it slides off the valve stem.
Valve stem,no! I don't know of a way to remove it (and not destroy it)once it was pulled through the hole. Get Mitsu valve...

My guess is that your radiator fan is not working.

That is why the A/C works at higher speeds and nothing to pull the heat from the condenser at a stop or slow speeds.

The diagnostic trouble...

Please check for the IOD fuse to be fully inserted.
The small plastic door/cover in front of driver's left knee pops out with a small screw driver of knife.

Then you will see a yellow plastic...

They opened a gas station in my area that sells ethanol free gasoline. I gave it a try just to see how much of a difference it makes. It turned out to be one of my worst tanks at that time!(about a...