Is that true for all American Mirages? AFAIK there are no blanking plates in my Space Star. I have a mirror adjustment, a head light adjustment and an ASG switch.
Printable View
We don't have headlight adjust here
I understand all that. It means that the Micra motor should get better mileage in a Versa. And it does. But the Versas I rented all got mileage comparable to our Mirages at 80-85mph. At this speed the Mirage engine is pushing 4k rpm while the Note is loafing at 2000rpm (IIRC). So in theory if Nissan pushed the Versa motor to a higher load it should produce even better mileage. But obviously it doesn't or they would have.
I am still amazed that both Versas I rented did 16k/L @125-130kmh. They were so quiet with the motors loafing I could whisper in the cabin and be heard. But I digress.
I'd like a kit where I just make the connections to my Outlander wheel, add my pedal switches and away I go.
Unfortunately, I highly doubt it will. However, I do plan on making a step by step tutorial with pictures and possibly video if necessary to make it super clear and easy so anyone can do it.
Not at all. It can certainly be done, but it will cost more. :)Quote:
Of course it would be great to have a plug-n-play solution without any wires to cut/solder...but that's probably asking too much.
My Mirage is a 2014 DE. There are 3 plate openings to use. Mine has the traction control button in one, and the bluetooth in the other. It has one blank plate available to be used.
Here is a picture I snapped after pulling out the blank.
Attachment 10687
Alternatively, I've considered putting the cruise switches in the blanked out push button start circle. It might actually be easier to reach / see while driving too. I do think it will be a bit harder to get to for installation purposes though.
Thanks for the ideas guys!
So, we have the rough idea of the project down I think. Lets get a bit more into the nitty gritty.
The part of the cruise system that I am recreating is actually really simple. Its four switches, four resistors, and only two wires (3 & 4 on the diagram) to hook up. This is great news, because with only two wires, installation will be very easy. If we take a look in the service manual, they lay this all out for us. The other two wires (5 & 6)that are part of the diagram are only for illumination. For the time being, we'll just ignore them.
Attachment 10693
By pressing the different buttons, the output wire sends a different voltage to the ECU. The ECU reads the voltage and knows what button is pressed. This is also specified in the service manual.
Attachment 10692
So, what needs to be recreated is simply some switches, resistors, and two wires as I mentioned earlier. Ideally, its neatly and nicely packaged in some easy to use form. This will replace the fancy ES steering wheel with its buttons on it.
Looks good to me!
If the Rostra aftermarket unit doesn't doesn't require etacs programming, I assume your design wouldn't, either...right? :confused:
The Rostra cruise kit has its own computer that you must wire in.
The kit I'm developing will use the OEM ECU's cruise control logic. I am quite certain that it will require etacs reprogramming. I plan on doing a complete and through write up on exactly what is necessary to do to enable cruise.