Car missing at lower rpm badly and randomly revs

[Rowdy]

So I have a 19 mirage 46k miles. Whenever I start it, it often kills itself, I have to give it a dab of throttle to keep it from stalling and then it idles at 1.5k, sometimes revs up and down from 900-2k and sounds like it's missing on a cylinder. But when throttle is applied it runs fine, and at higher rpm (above 2k) it runs normal.
I took it to autozone to run a obd2 on it and the following came up.
P0011 - intake camshaft position timing - over-advanced (bank 1)
P0016 - 1. Crank/Cam position phase. 2. Crankshaft position sensor phase. 3.camshaft position sensor. 4. Crank/cam position correlation.
And finally
C1225 - Deviation between wheel speed.

Only have check engine light on, and airbag light on.

[7milesout]

Hey Rowdy -

• Did you just buy the car used?
• Or have you had it from new and know the history?
• And is the car MT or CVT?

You are on the right path to come in here and ask. Fummins & Johnny Mullet are going to be your best resources on this.

Right off hand, I would think you have a sensor issue going on. And the bad sensor is throwing things off.

Let us know the bullet points above, give is some background.

[Rowdy]

Manual, bought it new, I drive it hard sometimes (cause I'm 12 and wanna go fast), I drive truck so it'll sit for 1-3 weeks at a time. Have not done anything maintenance wise to the engine beside air filter.

[Johnny Mullet]

Do you know when the last time the oil was changed? Is it the right viscosity? Sounds like something is gummed up or stuck in the MIVEC timing components.

[Fummins]

I'd start by checking out the wiring from the camshaft sensor.Attachment 26573Attachment 26574Attachment 26575

[Rowdy]

Do you know when the last time the oil was changed? Is it the right viscosity? Sounds like something is gummed up or stuck in the MIVEC timing components.

I always have pennzoil 0-20 synthetic

[Rowdy]

Looks fine, all of the wiring look good

[Fummins]

It usually looks good from the outside. They're infamously known for breaking and corroding wires where the factory ziptied the harness.
https://mirageforum.com/forum/showth...l=1#post158596

[Rowdy]

It usually looks good from the outside. They're infamously known for breaking and corroding wires where the factory ziptied the harness.
https://mirageforum.com/forum/showth...l=1#post158596

I gotcha, it's weird cause now it's running fine. So it must have bad wiring or something

[Rowdy]

Past 3 days it was running terrible and now it's fine