That looks nice GooneyGooney. I like the bit of chrome around it.
That looks nice GooneyGooney. I like the bit of chrome around it.
Custom Mirage products: Cruise control kit, Glove box light, MAF sensor housing, Rear sway bar, Upper grill block
Current project: DIY Nitrous oxide setup for ~$100
__________________________________________
View my fuel log 2015 Mirage DE 1.2 manual: 47.2 mpg (US) ... 20.1 km/L ... 5.0 L/100 km ... 56.7 mpg (Imp)
@kissfan, i got it at our local ace hardware shop here in the philippines
@daox, thanks! I think it made the illusion of making logo/emblem look smaller.
__________________________________________
View my fuel log 2014 Mirage ES 1.2 automatic: 44.3 mpg (US) ... 18.8 km/L ... 5.3 L/100 km ... 53.2 mpg (Imp)
http://www.amazon.com/3M-Scotchprint...car+vinyl+wrap
I swear by 3M vinyl wrap for ease of application, it holds up to weather nicely too, but unsure about UV protection. I'm sure you can wax over it though.
My question is? What you use to go from Rough cut to make the Finished Look, look so good?
__________________________________________
View my fuel log 2013 Mirage 1.0 manual: 47.5 mpg (US) ... 20.2 km/L ... 5.0 L/100 km ... 57.0 mpg (Imp)
Yes I used a brand new xacto knife. Careful cutting as to not damage the emblem or vehicle paint
__________________________________________
View my fuel log 2014 Mirage ES 1.2 automatic: 44.3 mpg (US) ... 18.8 km/L ... 5.3 L/100 km ... 53.2 mpg (Imp)
Does anyone know where to buy the pre-made logo stickers?