Somewhat more envoled than I thought it would be but they are both in.
I was able to skip a few steps, like needing to remove the whole console, you dont.
You also don't need to trim the bottom or cut out for that rear bolt. The template was almost worthless as well. The mounting post almost fills the whole cup holder. You don't need much of a template to drill the three holes.
I like it gives a little much needed storage. Little being the key word. Not a ton of room in there but enough for my large psi gauge, scan gauge manuals, a pen and insurance paperwork.
I also relocated my SG E to my dash. It had to come off for this install and it's easier to see on the dash.