Hey guys I made too much silicone last night and needed something quick to mold. I grabbed the Mirage pullback racer that was on my desk and tossed it in. I pulled it this morning and did a quick test pour to see how well it worked for being a "hot wheel"
I believe that when I clean up the mold and add it to the pressure tank I will get a much better pull on it than this one. I plan on adding a screw eye so I can put it on my key chain. I'm not sure what the final will look like as the pull back motor on the bottom seems to have interfered with the molding. Well that and the bits caught up in the wheels.
Anyone interested in a copy of it? I should be able to do it in most of the Mirage colors and they will glow in the dark. Cost would be material (roughly $8) plus shipping. I have attached pictures of this bubble infested one but this is not what the final product would look like. This one was just poured free hand before I jumped in the shower so it wasn't pressurized as I didn't want to run the compressor that early and wake people up.