Hi There!
Because i wanted to have an Eyeglass holder or even for my Shades but it'll take time before i could get my hands on the item so i managed to DIY instead!
Recycle is the way! :)
Attachment 12091
Printable View
Hi There!
Because i wanted to have an Eyeglass holder or even for my Shades but it'll take time before i could get my hands on the item so i managed to DIY instead!
Recycle is the way! :)
Attachment 12091
First use a flat screw to remove the tabs from the upholstery driver side. Since i dont have a handle on this part.
Attachment 12092
Then you measure as to where you'll put holes on the plastic.
I only used the Circle hole to measure because the plastic is a bit short.
Attachment 12093
This is how it look with the holes in it.
Attachment 12101
Also, from the bottom of the plastic holder since the tab cannot be inserted without any holes heres what i did.
Attachment 12102
Now, here's what it looks like with the tabs installed on the plastic holder
Attachment 12103
Attachment 12104
Lastly for the cover,
I put the blue string on the cover as a handle.
And i cut the part on the plastic holder cover because it will not get through since the tab at the back of it is blocking it.
Attachment 12105
And here it is! you Glass holder!! hahaha
Attachment 12106
Attachment 12107
Nice job! I like the recycling too.
I've added this to our Mods list. Thanks!