Search:

Type: Posts; User: klroger

Page 1 of 17 1 2 3 4

Search: Search took 0.03 seconds.

  1. Sorry, I'm going to have to ask what "Lambda"...

    Sorry, I'm going to have to ask what "Lambda" is.. I don't know fancy words.., Why would you use different words or measurements for 2 same sensors??? Are the 2 signals the same if you look at them...
  2. Yes, the voltage would be low. How are you...

    Yes, the voltage would be low. How are you determining it's Rich when the code is for a lean condition???
  3. Lean means there is too much O2 in the exhaust...

    Lean means there is too much O2 in the exhaust gas. As the converter works, it takes O2 out of the exhaust gas to use in the catalyst reaction. . The cat monitor is seeing too much O2 in the exhaust...
  4. See post 34 ;)

    See post 34 ;)
  5. Replies
    42
    Views
    6,544

    Nice :) . Looks like it was worth the wait!!!

    Nice :) . Looks like it was worth the wait!!!
  6. Have you been able to get a good weld with the...

    Have you been able to get a good weld with the Flux Core Wire??? I have a Mig Pac140 Lincoln with the flux core wire & I can't for the life of me make a weld I'm happy with no mater how much I grind...
  7. If both upstream & down stream sensors read the...

    If both upstream & down stream sensors read the same, you Do need a converter. If it's running rich, (high voltage) there's the cause of the converter failure...
  8. See if you can do something about the rodents...

    See if you can do something about the rodents chewing on your hoses before they start on your wiring harness & brake hoses. :(
  9. Replies
    71
    Views
    3,454

    After 62 posts since New Years, I wonder if this...

    After 62 posts since New Years, I wonder if this guy has any intention to buy a clutch or is he just janking our chains???. He's had a lot of suggestions given to him but has ignored or passed them...
  10. Replies
    71
    Views
    3,454

    When I was working as a Mechanic for a Transport...

    When I was working as a Mechanic for a Transport company with ~75 Class 8 tractors, the boss decided to get 6 trucks with the Automated Meritor 15 speeds coupled to the 515HP DD. They were the...
  11. Replies
    8
    Views
    316

    Check some wrecking yards to see if they may have...

    Check some wrecking yards to see if they may have a set. Other rims also fit the Mirage. I think the MINI rims look nice...
  12. Replies
    71
    Views
    3,454

    it's unusual if your clutch has a slip in 1st...

    it's unusual if your clutch has a slip in 1st gear & not any others. Usually when a clutch starts to go bad, it starts to slip in the higher gears. Have you adjusted it??? Sorry, I'm just a licensed...
  13. Replies
    71
    Views
    3,454

    If you don't need one, I don't think you should...

    If you don't need one, I don't think you should get really wound up about availability... if you need a spare clutch "JUST IN CASE" maybe you should revisit your driving habits???
  14. Replies
    71
    Views
    3,454

    The wrench monkey shows stock....

    The wrench monkey shows stock. https://www.thewrenchmonkey.ca/auto-parts/mitsubishi/mirage/2015/clutch-kit/ The don't show a price, it says call for price, but it's only a phone call. And they show...
  15. Replies
    71
    Views
    3,454

    I know you tried them before, but Rock Auto shows...

    I know you tried them before, but Rock Auto shows stock again. What about your FLAPS ??? (Friendly Local Auto Parts Store :) )
  16. Replies
    64
    Views
    8,656

    I don't understand it. I just built a new (base)...

    I don't understand it. I just built a new (base) Jeep on their Canadian site & with delivery, before Tax was 40,540.00.Why would anyone pay 50,000.00 for a used 4 wheeler they can't even drive on the...
  17. Replies
    34
    Views
    10,701

    It's deceiving, but if you put it in recirc as...

    It's deceiving, but if you put it in recirc as you have & get a small mirror & flashlight & look into the area below the letter "A", you'll see the top of the cabin air filter. The outside air comes...
  18. Replies
    34
    Views
    10,701

    It's the door he already has, as it rotates, the...

    It's the door he already has, as it rotates, the back of it closes the passage from outside to the heater plenum when he has it in recirc... That's why the door rotates in an arc, instead of sliding...
  19. Replies
    34
    Views
    10,701

    Recirc ALWAYS blocks off outside air. The back of...

    Recirc ALWAYS blocks off outside air. The back of the door blocks off the passage from outside into the heater plenum. You can see the outside to inside opening for a second just as you're moving it...
  20. Replies
    21
    Views
    1,154

    Umm, no. this is not a function of EGR. It has...

    Umm, no. this is not a function of EGR. It has nothing to do with warm-up as an EGR valve won't even function until the engine is warm. The valve allows a metered amount of exhaust gas into the...
  21. How bad are the threads??? Could you use one of...

    How bad are the threads??? Could you use one of these to help restore them??...
  22. Hey Highwire, I have 70,000km on it & it's 20...

    Hey Highwire, I have 70,000km on it & it's 20 years old in April. I've never done any kind of cleaning to the engine, other then regular washing of the outside. All the maintenance I have done is 1...
  23. Replies
    10
    Views
    468

    I think Mohammad's idea is perfect for what you...

    I think Mohammad's idea is perfect for what you want. Run a control cable into the dash & you wouldn't even need to open the hood to turn it on or off!!!
  24. Replies
    18
    Views
    1,033

    Hey Mark, do you have a block heater in your...

    Hey Mark, do you have a block heater in your mirage?? They aren't that expensive & only take moments to install. They're a cartridge so you don't need to drain the coolant... We had -27C (~-16F) this...
  25. Highwire, as far as the e-10 goes, I think it...

    Highwire, as far as the e-10 goes, I think it comes down to maintenance. I have a small Engine repair business & I'll estimate 75ish % of my work is carb & fuel related. Especially now with snow...
Results 1 to 25 of 416
Page 1 of 17 1 2 3 4