WALEEDMANGO, its missing whole second row, so I cut the wire for light+ and used the empty pin. Also, you need to change it on both sides of the clock spiral. There is little 'bridge' plastic on connector. You just need to lift 1mm and you can pull the wire out.
Last edited by Rockabilly Manta; 04-08-2019 at 05:44 PM.
WALEEDMANGO (04-22-2019)
Yes that type of clockspring has full 10 pins for c301, found several on ebay.au but all sold out. It labeled 14ch, ours with 5 pins only 7ch.
Last edited by FreeYourSOUL; 04-08-2019 at 06:11 PM.
Found this thread, https://minkara.carview.co.jp/smart/...3259/note.aspx
Guy replaced EK's inner wire (same part number with our mirage) with wires from outlander's clockspring.
I already have outlander's clockspring, so i may try this mod.
Rockabilly Manta (04-08-2019)
Thanks for great info
I bought this clock spring part number 8619A362 used from eBay, It may fit the car but i'm not sure.
I will write back when it arrives
Last edited by WALEEDMANGO; 04-20-2019 at 12:50 AM.
FreeYourSOUL (04-20-2019),Rockabilly Manta (04-20-2019)
I wonder if it fits for RHD too since there is LH or RH sticker on the bottom part.Originally Posted by WALEEDMANGO
Once I receive it, I will post detailed pictures here so everyone can check compatibility, I just need to figure out the ECU pins because 93&94 are occupied already.
Can you take some pictures of your ECU? and socket on the back of clockspring.
The pictures of the ECU connectors and Back of clock spring
Last edited by WALEEDMANGO; 04-22-2019 at 05:11 PM.
So you are loosing audio. Why not to cut blue for light and use empty??? Leave audio
Personally I care about night illumination more than audio controls
Posting Permissions
Bishi
Reply With Quote
2018 Mitsubishi Xpander Sport
Titanium Mira