2013 Honda Vario CBS VB
2014 Mitsubishi Mirage CVT EGM
2015 Toyota Innova 2.5V AT SMM
2013 Proton Preve CFE CVT PW
2013 Mitsubishi Outlander Sport PX CVT PW
2016 Mitsubishi Pajero Sport Dakar AT TGM Limited
__________________________________________
View my fuel log 2014 Mirage Exceed 1.2 automatic: 39.0 mpg (US) ... 16.6 km/L ... 6.0 L/100 km ... 46.8 mpg (Imp)
Then what's the post back on page 11, saying power went from 78 to 95?
2018 mirage ES manual
__________________________________________
View my fuel log 2018 Mirage Es 1.2 manual: 41.6 mpg (US) ... 17.7 km/L ... 5.7 L/100 km ... 50.0 mpg (Imp)
Any links for the can bus module? I googled but I am not sure which item is the correct one.
Hmmm.. so bro satria you are a tuner yourself in Indonesia. I might consider sending you my ecu for tuning since it’s nearby to Singapore. But I have intake and exhaust done.
Speaking of cams, I am still trying to get my hands on the cams from Thailand M’s Racing. Their Machine is down so still waiting.
I think this is the one.
https://www.tactrix.com/index.php?op...ed=1&Itemid=53
Qrush (07-22-2018)
Good to know. Maybe this is why I had a "brick"?
So, the pcmflash+mitsubishi canbus module are here?:
http://ecutools.eu/chip-tuning/pcmflash/
and module #24?
Custom Mirage products: Cruise control kit, Glove box light, MAF sensor housing, Rear sway bar, Upper grill block
Current project: DIY Nitrous oxide setup for ~$100
__________________________________________
View my fuel log 2015 Mirage DE 1.2 manual: 47.2 mpg (US) ... 20.1 km/L ... 5.0 L/100 km ... 56.7 mpg (Imp)
Qrush (07-23-2018)
Latest response from Megasquirt:
"Looks like the 6G75 decoder was the same for the crank but not the cam. Right now your options would be to run a 36-1 crank trigger - custom wheel decoders have been written in the past but often required a $500 development charge and some testing on the part of the person requesting the decoder. We'd need for you to install an MS3 (MegaSquirt 3) on the car and record a composite log, which the code team will use to create a test firmware. We'll then need you to try the test firmware on the car and get it running. If the car has no timing marks, you'll need to use a piston stop to find TDC and paint some timing marks on the engine to confirm timing."