Results 1 to 2 of 2

Thread: Rigging up bulbs using factory Fogs?

  1. #1
    Senior Member
    Join Date
    Nov 2017
    Location
    Squamish
    Country
    Canada
    Posts
    135
    Thanks
    0
    Thanked 47 Times in 29 Posts

    Rigging up bulbs using factory Fogs?

    So, I have a fog light switch on the multi stock, but obviously, no fogs.

    On my Jeep, all I had to do was tap into the factory wiring (left tucked into the fog location), get the dealer to flash the BCM to allow fog light control, and wire in a custom harness for reasons that I doubt will be an issue on the Mirage.

    Do I have factory wiring ready to go?
    What needs to happen to make the switch function?
    Will I be able to run whatever I want off that power source or does the Mirage detect non-factory voltages and shut the circuit down like a piece of crap Jeep (see above)


        __________________________________________

        click to view fuel log View my fuel log 2018 Mirage ES 1.2 manual: 43.1 mpg (US) ... 18.3 km/L ... 5.5 L/100 km ... 51.7 mpg (Imp)


  2. #2
    Senior Member Fummins's Avatar
    Join Date
    Oct 2016
    Location
    Alberta eh
    Country
    Canada
    Posts
    1,226
    Thanks
    492
    Thanked 708 Times in 405 Posts
    Skip to page 3 http://mirageforum.com/forum/showthr...wiring-)/page3

    The wiring is there tapped to the frame rails. You'll need to add a relay and get the computer flashed.



  3. The Following User Says Thank You to Fummins For This Useful Post:

    Daox (01-30-2018)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •