Installed an Android Radio

[Eggman]

Did your car have a secondary plug 18pins?. Mine does and I haven't been able to figure out its map. I think its for steering wheel controls. My vehicle did not have factory navigation.

If it helps any, steering wheel controls should be only two wires.

[alishaikh]

If it helps any, steering wheel controls should be only two wires.

I did some research on it using this forum. Looked at the wiring diagrams published on the main page and figured out that the 20 pin plug is C-09 which is the standard radio plug. The 18 pin plug i think is C-07 and is for MMES (Mitsubishi Multimedia Entertainment System).
Once i complete the map for the 18Pin for my car Mitsubishi Mirage 2013 (without Factory Navigation), I'll publish it here. The 20pin plug map is already on the first page of this this thread "Many Thanks to Alex".

[Pryme]

That rear camera sure does look a lot nicer than stock.
That throttle % gauge is pretty cool, what % do you find yourself using normally?

[flip096]

i have an older xtrons model...i modded it cause overheats over time...i suggest you do the same when it is already out of warranty...i drilled the top part of housing, 3d printed a fan mesh and screwed a 10mm fan...wire the fan to ground and acc...added some generic heatsink from ebay on top of the processor...these units tends to overheat when youre using multiple apps requiring more ram usage together with playing music on full volume and using bluetooth and wifi at the same time..i also assume that this will generate more heat if you have amplifier hooked up.. i also used the usb on this one to power up multiple usb devices by expanding the usb using a 4 port usb hub like my dashcam.. all usb devices that i attached to the expansion hub automatically turns on when you start the car...it is much easier way to do this if you have a lazy nature like me if you dont want to hardwire stuff that requires low power... this is what mine looks like after installation...