The Maintenance Manual requires "Inspect and adjust intake and exhaust valve clearance" every 32,000 km in Canada. What do you think that would involve?
The Maintenance Manual requires "Inspect and adjust intake and exhaust valve clearance" every 32,000 km in Canada. What do you think that would involve?
__________________________________________
View my fuel log 2014 Mirage SE 1.2 automatic: 46.4 mpg (US) ... 19.7 km/L ... 5.1 L/100 km ... 55.8 mpg (Imp)
__________________________________________
View my fuel log 2014 Mirage ES 1.2 automatic: 37.6 mpg (US) ... 16.0 km/L ... 6.3 L/100 km ... 45.2 mpg (Imp)
Can't find info, or shims.
Last edited by Justamirage; 02-27-2017 at 03:06 AM.
On my 92 Sentra there was no recommended valve adjustment interval. They were shimmed like a motorcycle but the range allowed was .013inch with the maximum at .023 and minimum at .010. I adjusted my 1973 Alfa Romeo once when I did a valve job at 58k miles. The car would foul the plugs at idle after a few minutes. Pulled the head and found the engine had no exhaust valve seals from the factory. I put some Mercedes seals for a 280 SL and valve guides from same so the seals had a place to attach.
100K miles later I checked them and they all were .001 less than when they were adjusted. At that rate it would have been 500k miles before they needed attention and the whole engine would be worn out by that mileage.
There is no recommended valve adjustment interval on the Mirage, either they are hydraulic, or like the Sentra, that interval is hundreds of thousands of miles.
regards
mech
__________________________________________
View my fuel log 2015 Mirage de 1.2 manual: 55.7 mpg (US) ... 23.7 km/L ... 4.2 L/100 km ... 66.9 mpg (Imp)
BRagland (02-01-2016)
My Maintenance Manual requires "Inspect and adjust intake and exhaust valve clearance" every 32,000 km in Canada. Are you saying that this is not required in other countries?
__________________________________________
View my fuel log 2014 Mirage SE 1.2 automatic: 46.4 mpg (US) ... 19.7 km/L ... 5.1 L/100 km ... 55.8 mpg (Imp)
So no valve adjument is required in the U.S.??
Valve adjustment as needed in the U.S.
2014 ES F5MBD aka 5MT. I am a full time Uber driver, if you want to drive for uber DO not sign up without my referral code for a bonus .
__________________________________________
View my fuel log 2014 Mirage ES 1.2 manual: 44.8 mpg (US) ... 19.1 km/L ... 5.2 L/100 km ... 53.9 mpg (Imp)
__________________________________________
View my fuel log 2014 Mirage ES 1.2 manual: 46.0 mpg (US) ... 19.5 km/L ... 5.1 L/100 km ... 55.2 mpg (Imp)
Sorry, but you are mistaken. The bucket comes in varying thickness end plates. Old Jaguar six cylinder dohc engines and countless Japanese motorcycles used similar setups. The difference is that those engines used removable pucks on the tops of the buckets or little varying thickness 'top hats' on top of the valve stems, just under the bucket.
The use of a complete bucket instead of shims probably adds to the cost, but if adjustments are few and far between, it shouldn't matter.
I would be more concerned with the dealerships using unqualified mechanics to do the arithmetic needed to calculate the required bucket thickness to bring clearances back to spec. It is subtraction and addition, after all.
__________________________________________
View my fuel log 2017 Mirage ESpecially frugal hatch 1.2 manual: 49.3 mpg (US) ... 20.9 km/L ... 4.8 L/100 km ... 59.1 mpg (Imp)
BRagland (02-01-2016)