@FreeYourSOUL THX I bought a cable from crashed car and disconnect pins
I made all wirings that are missed. I change a Clock sprong from 5 to 10 Pins. But i have some problems.
1. I have 5[V] on ECU pin 94 so i put a cable on ECU 3rd connector pointing from right side (C-227).
2. I change brake switch to 4 pins and make a extra wirings but on Pin 121 in conector C-228 i don't have any Voltage it is right?
Any idea what mistake i made?
I make some photos and film. The stering wheel wokr fine it chnge voltage properly.
PLS HELP!
And Film