Fog lights installation (how to enable without ETACS/computer connection)

[Bristol]

Hello All,

Installed my fog lights in my 2019 ES last weekend. Set up appointment to have the dealership use ETACS to enable the lights.
The charge? $103.00 Geez!
Now, I ordered my fog lights through mitsubishipartsnow.com and the installation instructions that came with the lights had a procedure to enable the lights once they were installed. But, because of reading all the posts here about the fog lights needing to be enabled by the dealer, I dismissed the instructions and did not try to enable them myself.
So today, I got to thinking about the instruction sheet again(thankfully I kept it) and re-read the procedure.
Curiosity got the better of me, so I went out to the car, ran the enable procedure, and, lo and behold, I have working foglights.
SWEET!
I am assuming the are on full strength. They look like it. Hard to tell in the daylight. So, I will check them out again after dark.
I dont know if this works for any other model years or not. I would assume it would work, at the
very least, for model years 2017-2019. But, I dont know?
If I can remember how I posted pictures once before, then I will post the page that describes the enable procedure.