This has been a huge pita but I wanted to document it all and still need help finishing this up.


So it looks good and all but it provides no light output

You get to V like shapes and in the middle of those v is a dead spot of light. So seeing directly in front of you provides no light.

I found nice plastic covers and grinded everything around the housing to fit them over properly. They keep water out nicely.


This has to be cut and you'll need to remove the housing off the HID housing instead of the halogen one. Black is ground and Green is hot. Almost the same with the other. Blue goes to green.

So this is how it looked when I had no black rubber around the back. It seemed to be bright and work great however I dont know because I tested it with only 1 light in the HID assembly and one in the Halogen until the other came in.

Would totally love suggestions as to why the LEDs in the HID assemblies provide next to no light.