Just at the dealer for the third time today. They did a fluid change in my cvt.. and over filled it a lot. About 1cm above the bend.

Then they drained it down and i checked it again.
It was just at the bottom of the bend.. and the tech tells me. Its fine there. Unlike an engine there are no Pistons to hit the oil so better over then low.

(I don't really believe that)
I did not push then, drove it 50 and checked it again and it was s little higher, which i could not accept
So I'm back at the dealer getting them to put at as close to the top of the H Mark as possible and if they can't.. put it a little low and give me some fluid to fill it slowly..

Am i being too paranoid?
How much over is still safe?