Is the hood out of whack or is it the bumper/rad support?
If you lean too hard on the tin foil rad support you can bend it.(same goes for the upper fender supports).
It might be worth a try just grabbing the top passenger side corner of the rad support(upper tie bar) kinda where you have it circled and give it a yank. Or could try backing off the 10mm bolts that hold the bumper cover to the tie bar and try to adjust the bumper forwards a little on the rh side?
Maybe take a look underneath as well to see make sure it didn't get hit(ran into something) from below. The rad supports are just as flimsly down low as up above. But usually if the bottom is tweaked back you'll see the bumper is bent/kinked where it meets the fender though.
It's kinda hard to say from the pic though. The headlight to bumper gap doesn't look weird so I dunno..
__________________________________________
View my fuel log 2014 Mirage SE wussie cvt edition. 1.2 automatic: 37.7 mpg (US) ... 16.0 km/L ... 6.2 L/100 km ... 45.3 mpg (Imp)