Hi, i have a mirage Turbo in Puerto Rico. I need to know is i can use a rods from a nother car to forge my engine. Any help is appreciated.
Hi, i have a mirage Turbo in Puerto Rico. I need to know is i can use a rods from a nother car to forge my engine. Any help is appreciated.
Hello and welcome to the forum Cris051.
I moved your post into its own thread to give it more attention.
Its a possibility that you could find rods from another engine, but you would have to get your measurements and talk with a rod company about that. I don't think we have anyone who has replaced their rods with aftermarket rods yet.
Custom Mirage products: Cruise control kit, Glove box light, MAF sensor housing, Rear sway bar, Upper grill block
Current project: DIY Nitrous oxide setup for ~$100
__________________________________________
View my fuel log 2015 Mirage DE 1.2 manual: 47.2 mpg (US) ... 20.1 km/L ... 5.0 L/100 km ... 56.7 mpg (Imp)
Hello
Thanks bro, i was searching for another engine who has the same stroke and bore. The 3A92 is stroke 75mm and Bore 90mm. And the Honda D series has the same spec in stroke and Bore. But i not sure if i can use the Rods and Pistons of that Honda. Thi is my car
__________________________________________
View my fuel log 2017 Mirage ESpecially frugal hatch 1.2 manual: 49.3 mpg (US) ... 20.9 km/L ... 4.8 L/100 km ... 59.1 mpg (Imp)
And in Puerto Rico we are tuning the ECU doing the Reflash. No piggyback no other computer. The max HP we get is 119 9psi"boost", internal stock.
Christopher_B (02-11-2021),Daox (06-06-2017),gone.a (06-06-2017),MetroMPG (06-06-2017)
__________________________________________
View my fuel log 2015 Mirage ES 1.2 manual: 49.6 mpg (US) ... 21.1 km/L ... 4.7 L/100 km ... 59.5 mpg (Imp)
Hi there,
That's amazing work you have done to get to flash and turbo the car all using stock components.
With a cvt how do you do a dyno run?
I tried dynoing my cvt and it's not accurate and gives higher than normal Hp figures.
Any techniques or tricks to keep it in gear? Like which rpm and speed to start the run and at which rpm to cut the run?
Thanks in advanced!