emergency brake handle replaced and leather boot intalled
wellvisors wind deflector
bi xenon projector retrofit headlights with 3.0 shrouds
jdm carbon fiber painted license plate cover front and back
plastidipped front and back emblem
ralliart emblem
evo led side markers
all lights replaced with led
2.5 fog lights wid led halo rings
fog lights cover
black matte exhaust tip
evo tow hook
rally armor mudflaps
carbon fiber vinyl wrapped hood
carbon fiber vinyl wrapped roof
vox1 hd reverse camera
aftermarket front lip
plastidipped oem side skirt
plastidipped oem rear skirt
headlights and taillights trim cover
led dome lights
led cargo lights
wide angle rear view mirror
1080p dash cam
720p rear dash cam
momo shift knob
momo emergency brake handle
momo pedals
hud speedometer
underdash led
after market generic 2 din android head unit
350w boss 4 way speakers front and back
200w boss tweeter
k&n air filter
ultra racing front strut bar
godspeed coilovers
NS Series Wheels NS1204 Matte Black (NS1204 Wheels, 15" DIAMETER (15" x 7") [+38 Offset, 4x100 Bolt Pattern]
cquence drilled and slotted rotors
metallic brake pads
tire size 195/50r15
emergency brake handle replaced and leather boot intalled
cant wait to install this... got my front lip from the philippines!
front lip installed!
inuvik (07-23-2018)
retrofit projector installed
inuvik (08-28-2018)
Looking good!
Custom Mirage products: Cruise control kit, Glove box light, MAF sensor housing, Rear sway bar, Upper grill block
Current project: DIY Nitrous oxide setup for ~$100
__________________________________________
View my fuel log 2015 Mirage DE 1.2 manual: 47.2 mpg (US) ... 20.1 km/L ... 5.0 L/100 km ... 56.7 mpg (Imp)
Those look really nice. Are those the Panamera shrouds?
https://www.theretrofitsource.com/panamera.html
yup.. i got it from ebay...i also got a 2.5 inch - 3inch shroud bezel ring adapter to make it fit...
Did you do the retro yourself? I'm almost done with mine and I was going to use those shrouds as well. I tried fitting them in the reflector bowl, but the back of the shroud housing was too long. This would have required quite a bit of cutting and I just wasnt comfortable with it, being my 1st retro. I was gonna add the new RGBW inserts and thought I would run out of stable real estate to place them in.
got my coilovers today... will install it on the weekends...