Attempting to create a clear acrylic Kammback on the rear.
Not done yet but I got the hard part done,the curved pieces at the sides.
It will be made out of three pieces but I ran out of sheets. I only need a 10"X15" little piece to be able to finish so then I can start testing.
If it looks like it is going to work out and actually help reducing drag,I will do a more detailed writup.
Sofar this is what I got test fitted:
Is it too agressive?
I know it is hard to see but that is the point in using clear material.
BTW no drilling or scratching the car,completey reversable mod.
Questions to the experts:
Is the roughly half inch step down from the factory mini kamm an issue or should it be almost flush? (Harder to design that way)
Angles too much?