I don't think I'd be willing to give away instructions on how to make something I spent a lot of time making and sell for next to nothing. Although the amazon and ebay links are dead. https://mirageforum.com/forum/showth...amp-price-list
I don't think I'd be willing to give away instructions on how to make something I spent a lot of time making and sell for next to nothing. Although the amazon and ebay links are dead. https://mirageforum.com/forum/showth...amp-price-list
__________________________________________
View my fuel log 2014 Mirage SE wussie cvt edition. 1.2 automatic: 37.7 mpg (US) ... 16.0 km/L ... 6.2 L/100 km ... 45.3 mpg (Imp)
Sorry, but I don't sell stl files. I have done this a few times in the past, and every single time without fail I eventually find someone else selling my product somewhere else.
Also, PETG may very well be fine, but it is a lower temperature material than ABS.
Custom Mirage products: Cruise control kit, Glove box light, MAF sensor housing, Rear sway bar, Upper grill block
Current project: DIY Nitrous oxide setup for ~$100
__________________________________________
View my fuel log 2015 Mirage DE 1.2 manual: 47.2 mpg (US) ... 20.1 km/L ... 5.0 L/100 km ... 56.7 mpg (Imp)
Thank you I appreciate the response. I will end up doing an abs print just had not upgraded my printer to ventilate properly yet and i have petg on hand for some prototyping. Wanted to make modifications to allow for a mounting bracket and a 2 inch motorcycle filter for personal use. No worries will take measurements this weekend